Adapter T2 to 2", for 2" eyepieces to blocking filter

Set of 5 extension tubes with T2 thread on both sides for exact distances and secure hold of cameras for astrophotography. Also comes with SC to T2 thread adapter.In astrophotography, most cameras are connected to a telescope via a T2 thread (M42x0.75), the most popular international standard. However, in many cases, T2 and T2-ring adapters for connecting telescope focusers to a camera are not sufficient, as specific distances must also be observed. This is especially important when using correctors, reducers or flatteners. This extension tube set, which consists of 5 mm, 7.5 mm, 10 mm, 15 mm and 30 mm tubes, will allow you to obtain almost any distance using the corresponding combination. Each tube has a T2 interior thread on one side and a T2 exterior thread on the other side.Most telescopes either include a T2 thread adapter, or the eyepiece can be used with a simple T2 thread adapter with a 2” plug-in diameter (item no. 0510365).However, Maksutov-Cassegrain, Schmidt-Cassegrain, ACF or Ritchey–Chrétien telescopes may use a so-called SC thread. To allow you to use this extension tube set with these telescopes, the set also includes an SD to T2 thread adapter.FEATURES5 T2 tubes with lengths from 5 mm to 30 mmCombination of tubes allows you to obtain distances of 5 mm to 67.5 mmFor exact camera distances in astrophotographyDELIVERY CONTENT5x T2 extension tubes (5/7.5/10/15/30 mm)1x SC to T2 thread adapter

Enables you to connect a camera to telescopes that accept 2" barrel eyepieces. You will need a T2-ring for your special camera type also. The very special feature of this adaptor is the very short mechanical design (2.0mm) which enables the camera use also on telescopes with a short focal range. This adapter is also prepared to use with 2" filters.   

Ultra Light Dobsonian 254mm GENERATION II - with completely redesigned and improved construction.No telescope type has influenced amateur astronomy as radically as the dobsonian telescope. Before the introduction of this telescope type by John Dobson the vast majority of amateur telescopes were small inadequate refractors on shaky mounts - just good enough to show the polar regions on mars or the rings of Saturn. Bigger telescopes, like the Schmidt-Cassegrain telescopes, were restricted to the relatively small group of amateurs that could afford them.The brilliant combination of simple - but effective - mechanics and the largest aperture available led to a worldwide triumph of this concept. No other telescope type offers you so much light for your money as a good dobson. We have taken the motto "held together by gravity and driven by yoghurt power" and offer a modern version of the classic - designed by amateur astronomers for amateur astronomers. Despite its large aperture the telescope can be transported easily even in small cars and is assembled within minutes without tools. The construction was optimized for maximum rigidity with a minimum of mass. The combination of big altitude wheels and a optimized aluminium-sandwich construction allows for small movements even at high magnifications. The focus position is already positioned to accept our coma-corrector. The ideal workhorse for the deep-sky enthusiast. A telescope with 254mm aperture gathers more than 1300-times more light than the naked eye. Details on planetary surfaces stand out even to unexperienced observers, and countless deep-sky objects show details. Bright globular clusters are resolved down to the core and the view of the lunar terminator will provide a unforgettable experience.Dimensions for mobile use: Rockerbox 395mmx395mmx310mm; Mirrorbox 330mmx330mmx295mm; Trusses approx.700mmEyepiece Height while pointing at zenith approximately 1,15m; 10“ Net total weight: 26,4 kg; 10“ Mirror Box: 14 kg; 10“ Secondary cage +Rockerbox: 9,7kg; 10“ 4 Pairs of trusses: 1,5kg; 10“ Altitude Wheels: 1,2kg ; Focuser thread: M54 x 0.75 mm. Backfocus: 45mm behind the 2" eyepiece holder. 35mm when the 1.25" adapter is mountedSPECIFICATIONS Truss-Dobsonian Telescope in full Aluminium constructionNEW: Slider bearings made from TEFLON und GFK for smooth and precise movementNEW: Improved main mirror cell with completely redesigned mechanicsNEW: Altitude bearings with new designed brake and friction systemNEW: Universal finder slot to enable an easy finder upgradeNEW: Quick-lock fasteners with new springloaded design for comfortable useNEW: Powder-coated yellow altitude wheels to improve durabilityNEW: Laser engraved central mark on main mirrorSCOPE OF DELIVERYTruss Dobsonian TelescopeLED finder with standard finder slotStray light shield for secondary cageMain mirror collimation toolBattery compartment with bag for fansExtension tube for focuserReducer 2"/1.25"Manual

The LS130MT/B3400 telescopes can be upgraded with this conversion kit. This allows to explore the Sun at different wavelengths with one and the same telescope, and the telescope can also be used for observing and photographing the starry night sky.You can replace the H-Alpha system of the LS130MT/B3400 telescope with this conversion kit in just a few easy steps. This makes it possible to observe the sun in H-alpha, in the light of the Calcium-K wavelength, or in White-Light - with one and the same telescope!You will only need the additional Ca-K module for LS130MT (item number 0551697), or a LUNT Herschel-wedge (item number 0558201 or 0558211).But there is more: With this conversion kit the LS130MT/B3400 can also be used as a 3-lens apochromatic telescope for astronomical observations and photography at night!This conversion kit turns the LS130MT into a real all-round telescope!This conversion kit was specially designed for the LS130MT/B3400 H-Alpha telescope. Included is a completely new focuser. Simply loosen three knurled screws at the LS130MT/B3400, which hold the H-Alpha unit together with the focuser. Here the new focuser will be fixed, and you have already made your LS130MT a adequate triplet ED apochromatic telescope.This conversion kit can also be used at the LS130MT/B1200 and LS130MT/B1800 telescopes, but it is not necessary there. This conversion kit is only necessary at the LS130MT/B3400, because at this telescope the blocking filter is fix installed inside the focuser.SCOPE OF DELIVERY2" Focuser with 10:1 reduction and adapter to LS130MT telescopeInstruction manualLS130THa telescope not included! Can only be used together with an LS130MT solar telescope.Also available as set together with Ca-K module for LS130MT (item number 0551695)

Explore Scientific 82° Series™ extreme wide field eyepieces are optimized to produce high contrast, high resolution, and superior flat field characteristics. The visual effect of these eyepieces with their long eye-relief and their 82° apparent field is truly a full-immersion experience. Your eye is relaxed, allowing you to easily use the "averted vision" technique to study faint details across a huge field-of-view. The 82° Series eyepieces come with a twist-up rubber eye-guard that raise to the desired height for the comfort of the observer, and as experienced astronomers know, eye comfort is critical when trying to observe at the visual limits of the telescope. To keep internal reflections to a minimum, all internal surfaces of the eyepiece barrel are flat black, as well as the edges of the lenses themselves to minimize the scattering of light within the lenses themselves. All 82° Series eyepieces are fully multi-coated and edge-blackened to produce maximum contrast.

One eyepiece for every occasion The BRESSER zoom eyepiece covers the large focal length range from 8 to 24 mm. These are also the focal lengths most frequently used with most telescopes. Especially for instant observations, where you don't want to pack a whole suitcase full of eyepieces, the zoom eyepiece is a good choice. Always the ideal magnification on hand A quick turn and the ideal magnification for you is set. The adjustment is stepless from 8 to 24 mm focal length. This eliminates the need to always change eyepieces. Comfortable viewing The BRESSER zoom eyepiece offers a large comfortable eye relief of 20 mm to the eyepiece lens (LER = long eye relief). This means comfortable viewing even during longer observation, an important criterion especially for people with glasses. The rubber eyecup can also be individually adjusted by a twist and turn movement. Apparent field of view is 40 up to 56 degrees which offers a good overview. Advanced optical design To achieve the best possible image over the entire focal length range, a sophisticated optical design with 8 lenses in 5 groups is used. The full multi-coating on all lens surfaces also guarantees maximum light transmission. To effectively suppress unwanted reflections, all lenses are carefully blackened at the edges. Thus, the image produced offers the maximum possible contrast and image brightness. Compact and solid design The BRESSER zoom eyepiece is made entirely of black anodised aluminium. It has an extremely solid and high-quality material appearance and is long-lived even with extensive use. The precise zoom mechanism can be operated safely through the ribbed metal adjustment ring. A white laser engraving with focal length and pointer arrow indicates the currently set focal length even in low light. Achievable magnifications with common telescope focal lengths 350 mm: 44 - 15x 400 mm: 50 - 17x 500 mm: 63 - 21x 650 mm: 81 - 27x 750 mm: 94 - 31x 900 mm: 113 - 38x 1000 mm: 125 - 42x FEATURES Zoom eyepiece with stepless focal length adjustment from 8-24 mm One eyepiece covers a wide focal length range Continuous adjustment to the ideal magnification Quick adjustment of magnification without changing eyepieces Comfortable eye relief of 20 mm (LER = long eye relief) Adjustable rubber eyecup to adjust to the ideal interpupillary distance Also very suitable for people with glasses Compact and solid design Made entirely of black anodised aluminium Very high-quality material appearance Precise and robust zoom adjustment mechanism Ribbed handgrip for zoom adjustment White laser engraving with focal length and pointer arrow Focal length range 8-24 mm freely adjustable Apparent field of view 40 up to 56 degrees Optical design: 8 lenses in 5 groups All lens surfaces with full multi-coating for a bright and crispy image Eyepiece sleeve diameter: 1.25 inches / 31.7 mm Filter thread in sleeve: M28 x 0.6 mm (standard 1.25'' filter thread) Eyepiece weight: 250 g Length of eyepiece: 96.2 mm Diameter: 47 mm Colour: black SCOPE OF DELIVERY Zoom eyepiece Dust caps

Take pictures with your smartphone through the telescope or microskope? With the Smartphone camera adapter this is now child's play! Simply screw the adapter to the eyepiece and use your smartphone as a camera with a super-telephoto / super-macrophoto lens. It lets you take pictures of distant objects or very small objects as if you were very close.The Deluxe version offers an even more comfortable and secure attachment to the eyepiece. By a rotary movement of the clamping ring 3 clamping jaws are evenly applied to the eyepiece housing and the Smartphone adapter sits firmly and centrically on the eyepiece. The fine adjustment of the height of the smartphone support allows a quick and precise adjustment of the viewing height of the smartphone camera above the eyepiece lens. Good image results are thus guaranteed.  FEATURES Take photos through the telescope Smartphone camera with super telephoto lens Fine Height adjustment of phone support Wide adjustment range for eyepiece housing diameter Fits 31.7mm (1.25") eyepieces For eyepiece housing diameters from 22-38mm SCOPE OF DELIVERY Smartphone holder deluxeLocking ring for the smartphone